2016 Nissan Altima Transmission Fluid Pressure Sensor Location


The transmission fluid pressure sensor (TFPS) on a 2016 Nissan Altima is located inside the transmission beside the valve body. It is a small, cylindrical sensor with a electrical connector.

To access the TFPS, you will need to remove the transmission pan. This can be done by draining the transmission fluid and then removing the bolts that hold the pan in place. Once the pan is removed, you will be able to see the TFPS.

The TFPS is connected to the transmission by a wiring harness. Be careful not to damage the wiring harness when you are removing the TFPS.

To replace the TFPS, you will need to disconnect the wiring harness and then remove the old sensor. Be sure to install the new sensor in the same orientation as the old sensor.

Once the new sensor is installed, you can replace the transmission pan and fill the transmission with fluid.

Here are the steps on how to replace the transmission fluid pressure sensor on a 2016 Nissan Altima:

  1. Park the car on a level surface.
  2. Turn off the engine and let it cool down.
  3. Open the hood and locate the transmission fluid pan.
  4. Drain the transmission fluid by removing the drain plug.
  5. Remove the bolts that hold the transmission pan in place.
  6. Carefully remove the transmission pan.
  7. Locate the transmission fluid pressure sensor.
  8. Disconnect the wiring harness from the sensor.
  9. Remove the old sensor.
  10. Install the new sensor in the same orientation as the old sensor.
  11. Connect the wiring harness to the sensor.
  12. Replace the transmission pan and tighten the bolts.
  13. Fill the transmission with fluid.
  14. Start the engine and check for leaks.
See also  2015 Jeep Grand Cherokee 3.6 Coolant Temperature Sensor Location
How To Replace A Transmission Fluid Pressure Switch P0847 / P0848 / P0872 / P0873

The transmission fluid pressure sensor is a relatively inexpensive part. However, the labor costs to replace it can be significant. If you are not comfortable replacing the sensor yourself, you can take your car to a qualified mechanic.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *